![]() ![]() ![]() Please select the Internet interface from this list. Multiple network devices have been detected. Gcc -Wall -g -Dlinux -DPREFIX=\"/usr/local\" noip2.c -o noip2Īuto configuration for Linux client of. When do you "make install" you’ll be guided through your config wget ġ00% 134,188 174K/s in 0.8s You need to download it, extract it and then compile/install by following the steps below. So for me I wanted to download the no-ip source for linux. I use no-ip for my dynamic DNS and then just have a CNAME from my domain to the appropriate no-ip hosts with a 15 second TTL. Next it was to modify the IP of the Pi itself in /etc/network/interfaces to match the gateway above: This gives me a /etc/nf that looks like this: In my case all I need to change are the opt router and start/end addresses. The first step is to change the address range that udhcpd offers. This made very little sense at the time and even less now – so time to change it. Setup VPN connection from my car’s router to my main network border router – any 10.0.0.0/16 should flow hereįor some reason I setup my car as a 192.168.1.0/24 block.Install a dynamic DNS client on the Pi to keep the IP updated whenever the vehicle is online.I’m not sure my car is going to need a /24, but I’m not exactly short on address space. Change my car’s network over to the 10.2.0.0/24 network (10.0.0.0/16 is for my house network, 10.1.0.0/16 is for AWS services and 10.3.0.0/16 is where I allocate my /30s from).I’ve already got a pfsense installation for my border router so can easily add a new IPSec VPN node connecting in to it – with just a couple of quick changes to my existing setup. So having recently got my Carputer up and running I decided I wanted to connect it to my LAN at home and for my business. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |